Re: Beginner's questions
[ Follow-ups ] [ Post Follow-up ] [ The Henna Page Discussion Forum ] [ FAQ ]
Posted by SeeSee on September 04, 1999 at 18:27:01:
In Reply to: Re: Beginner's questions posted by Amy C on September 04, 1999 at 16:45:40:
Amy's got the right idea...if you decide to make your own cones out of flat plastic, try and make a long, thin cone as opposed to a short, fat cone. There is less chance that the hole will enlarge in the course of using the cone. I always had trouble with the bottle too, but then I switched to the cone and I found I couldn't control the hole size very well until I leaned the short-fat, long-thin difference. Does this make any sense? Last night I sifted Castle Arts henna once through a control top and not a single clog happened while I was working.
Follow-ups:
|