|'White henna' is not henna. 'White Henna is a technique similar to henna.
This 'white henna' work was created with Becoming Moonlight® Gilding Paste, gilding powder, glitter and gems. Becoming Moonlight® Gilding Paste is a FDA approved medical adhesive specially adapted for use by henna artists.
It could also be created with a similar medical adhesive 'white henna' paste such as Pros Aide Adhesive Cream.
|Becoming Moonlight® 'white henna' gilding paste is waterproof, safe for use on skin, and lasts from
three to ten days depending on care and location on skin, once it has been sealed with gilding powder or glitter.
You can shower with Becoming Moonlight® patterns on your skin, but don't scrub them, or vigorously rub them dry.
|Becoming Moonlight® is a group of
materials specially formulated to work together and extend the range of
colors and applications available to henna artists.
|Apply Becoming Moonlight® 'white henna' gilding paste with a cone as you would henna, but use much finer lines.
Cut the tip of a Becoming Moonlight® gilding paste cone.
The cone's hole should be much smaller than you would use for henna.
|Test the cone to see if you can make
the size of a cat’s whisker. That is my favorite size of line to
work with; this thin line will dry in about 10 minutes.
Thicker lines take longer to dry.
|Apply Becoming Moonlight® gilding paste on clean dry skin as you would apply henna.
Clean the skin before you begin. Remove oil, perspiration, and lotion from the skin for best results.
If you apply 'white henna' gilding paste to skin that is hairy, the hairs may get pulled out when the pattern is removed.
|If the tip of your cone becomes sticky, clean it with isopropyl alcohol|
|When you finish drawing, let Becoming Moonlight® gilding paste dry for about 10 minutes.|
Becoming Moonlight® gilding paste will not become completely transparent when it has dried; some will remain white. This will help you keep track of your work.
|Touch the 'white henna' gilding paste gently, to see if it has become firm and less sticky. |
When the paste is no longer wet and sticky, brush Becoming Moonlight® gilding powder or glitter over the paste.
If your brush sticks to the paste lines, stop, and let the paste dry for a few more minutes.
If you get gilding paste stuck in your brush, clean the brush with 91% isopropyl alcohol, and let the brush dry before using it again.
|Seal Becoming Moonlight® gilding paste with gilding powder or glitter or it will remain sticky and collect dust and crud. |
Generously brush gilding powder or glitter over all of the lines of gilding paste.
you have applied Becoming Moonlight® gilding powder or glitter to all
of the gilding paste, brush way the excess with a large, soft
Powder and glitter may cling to skin that is oily, lotioned, or damp with perspiration.
If you cannot remove all of the powder with the brush, you can rinse away the excess with water.
|Apply Becoming Moonlight® gems (flatback rhinestones) with Becoming Moonlight® gilding paste.|
Start by putting a tiny spot of gilding paste on the skin.
Pick up a gem with a birthday candle by pressing the candle to the domed side of the gem.
Lift the gem into positiona dn apply the gem to the paste.
|Apply some Becoming Moonlight® glitter for extra dazzle, and then brush away the excess. |
When all of the 'white henna' gilding paste is sealed with gilding powder and glitter, your 'white henna' is complete.
Visit the Henna Page
brick and mortar store
at 135 E. Main St., Kent, Ohio, USA
The Empire of Magical Thought
TapDancing Lizard® LLC group includes
The Henna Page®
Henna for Hair
Who Runs this Place?